Set of four black 3D printed hex-port storage sleeves with four knurled hex nuts

Bulletproof Isolator Rack Storage – Hex Port

Set of 4 / Black / Included
$90.00
$90.00
Skip to product information
Set of four black 3D printed hex-port storage sleeves with four knurled hex nuts
  • Set of four black 3D printed hex-port storage sleeves with four knurled hex nuts
  • Rack-mounted isolator storage sleeves holding Bulletproof Isolator accessories upright on a 3x3 rack crossmember
  • Set of four red hex-port isolator storage sleeves with knurled hex nuts
  • Set of four blue hex-port isolator storage sleeves with knurled hex nuts
  • Vertical view of hex-port storage sleeves on a 3x3 rack storing Bulletproof Isolator accessories
  • Close-up of 3D printed hex-port sleeves seated in the 1-inch holes of a 3x3 rack
  • Knurled 3D printed hex nut held in hand, used to secure the isolator storage sleeve to the rack
  • Red hex-port isolator storage sleeve with knurled hex nut
  • Blue hex-port isolator storage sleeve with knurled hex nut
Bulletproof Isolator Rack Storage – Hex Port

Bulletproof Isolator Rack Storage – Hex Port

$90.00
$90.00
Quantity
Color
M24 bolts & nuts

Rack-mount storage for your Bulletproof Isolator accessories. Each hex-port sleeve bolts through a 1-inch hole on a 3x3 rack and holds an isolator attachment upright and off the floor. Designed for M24 bolts and nuts, like the ones Rep includes with the PR-5000. Each port comes with a knurled 3D printed nut handle, though a wrench is usually the easiest way to tighten it.

Choose your setup

  • Quantity: a single port, or a set of 4.
  • Color: black, blue, red, orange, white, or green. Want a color that isn't listed? Message me and I'll check what filament I have on hand.
  • M24 bolts & nuts: add the M24 x 120 mm bolts and nuts if you don't already have them, or skip them if you do. The steel hardware is heavy, so shipping is calculated on the option you pick.

Fit

Fits 3x3 racks with 1-inch holes. Best for attachments with a narrow footprint at the base. Attachments with a wide base, or that spread outward, aren't recommended: the sleeve's sidewall isn't built for sideways pressure and may crack over time. Not sure if yours fits? Send me the accessory name or model before you order.

3D printed to order by LiftLayered.

You may also like